Set A consists of all prime numbers between 10 and 25; Set B

Question

Set A consists of all prime numbers between 10 and 25; Set B consists of consecutive even integers, and set C consists of consecutive multiples of 7. If all the three sets have an equal number of terms, which of the following represents the ranking of these sets in an ascending order of the standard deviation?

(A) C, A, B
(B) A, B, C
(C) C, B, A
(D) B, C, A
(E) B, A, C

(A) C, A, B 
(B) A, B, C 
(C) C, B, A 
(D) B, C, A 
(E) B, A, C

Bunuel · Accepted Answer

Set A - {11, 13, 17, 19, 23};
Set B - {5 consecutive even integers}, for example - {12, 14, 16, 18, 20};
Set C - {5 consecutive multiples of 7}, for example - {7, 14, 21, 28, 35}.

Now, the standard deviation of a set shows how much variation there is from the mean,  how widespread a given set is . So, a low standard deviation indicates that the data points tend to be very close to the mean, whereas high standard deviation indicates that the data are spread out over a large range of values.

You can see that set C is most widespread and set B is least widespread, so the correct answer is: B, A, C.

Answer: E.

punyadeep · Answer

thnx so much..........oa is incorrect then...!!

subhashghosh · Answer

A-> 11,13,17,19,23

B-> 0,2,4,6,8

C -> 7,14,21,28,35

So the answer is E, as C hax maximum gap between elements, and A has slightly more than B because of the last number - 23.

The OA seems to be wrong. Just curious to know where is this question from; I've seen two SD questions with wrong OA now.

punyadeep · Answer

the question is from 700-800 level questions.........however there is no source,,,if u wish i can upload the document cos i find this document very good...!!!

gmat1220 · Answer

SD will be high if the sample is not compact since SD is a measure of compactness.

Mean will fall in the middle of the highest and lowest. So more the distance from the mean - the higher the SD. Assuming all the data is  positive   the SD will be proportional to the  range   (highest - smallest)

Set A {11 13 17 19 23} range = 12
Se B {12 14 16 18 20} range = 8
Set C {14 21 28 35 42 } range = 28

SD(B) < SD(A) < SD(C)

Please correct me if this reasoning is wrong.

gmatpapa · Answer

Just my 2 cents: there are a lot of "good" documents around.. but least we can do is be careful on our part. If others didnt testify the right answer, I would have missed my dinner!

Edit: I just found out, this question is from Veritas Prep "Statistics and Problem Solving" book and the OA is indeed E.

punyadeep · Answer

@ fluke...two documents iam uploading......they were sent to me by a frnd who scored 750 and he just went through this document for quant twice.......i found it focussed and helpful too...!!

punyadeep · Answer

@ fluke...here r the answwers to it...!!

mau5 · Answer

Set A  	o {11,13,17,19,23}

Fact: Addition/subtraction of any number from a given set doesn't change the S.D of the given set.

From Set A, subtract 11 across to represent  Set A^'  as  	o {0,2,6,8,12} .  S.D of Set A = S.D of Set A^'

If you notice closely, Set  A^'  is very close to Set B, just that Set B looks like  	o{0,2,4,6,8} ,i.e. a data-point of 12 is present instead of 4, which makes  Set A^'  more spread-out then Set B.

Thus,  S.D of Set B< S.D of Set A^'

Assume Set C 	o {0,7,14,21,28}

S.D represents how far are the data points are from the mean of the set, we can see that Set C has the most spread-out data points and the correct order = B,A,C.

E.

blueseas · Answer

Hi, few things to keep in mind. =>std deviation depends on distance of each term from mean and number of terms.==>since number of terms are same..we are concerned only about distance of EACH TERM from MEAN.==more the distance more the deviation. =>std deviation is always positive==>so not concerned whether numbers are positive or negative. SET A==>(11,13,17,19,23)==>avg around 16==>you can see distance of 11,13,17,19,23 is 5,3,1,3,7....1) SET B==>(CONSECUTIVE EVEN INTEGERS...)= ( N-4,N-2,N,N+2,N+4)===>mean=N==>DISTANCE FROM MEAN= 4,2,0,2,4 SET C==>MULTIPLES OF 7 ====N-14,N-7,N,N+7,N+14===>MEAN=N====>DISTANCE FROM MEAN=14,7,0,7,14. if we compare all distance clearly we can say BHENCE OPTION E

bumpbot · Answer

Automated notice from GMAT Club BumpBot:

A member just gave Kudos to this thread, showing it’s still useful. I’ve bumped it to the top so more people can benefit. Feel free to add your own questions or solutions.

This post was generated automatically.

Set A consists of all prime numbers between 10 and 25; Set B

Prep Toolkit

Top 5 GMAT Debrief Videos

615 to 715 in 15 Days (Ria's Strategies)

More than Quant/Verbal Abilities: Speed vs. Accuracy

745 with Only Self-Prep and GMAT Club

From 555 to 765: 210-point Improvement

Perfect 805 Score Debrief by Julia

GMAT Problem Solving (PS) Questions

Set A consists of all prime numbers between 10 and 25; Set B

Prep Toolkit

615 to 715 in 15 Days (Ria's Strategies)

More than Quant/Verbal Abilities: Speed vs. Accuracy

745 with Only Self-Prep and GMAT Club

From 555 to 765: 210-point Improvement

Perfect 805 Score Debrief by Julia